Phone Setup - Cisco 8832 Manual

New and Changed for Firmware Release 11.3(1)
New and Changed for Firmware Release 11.3(1)
Revision
Added new task to support Auto Provisioning with
Short Activation Code.
Updated an existing task to support display UDI
feature on phone screen
Added a task to support Serviceability Enhancement
Messages for Provisioning Failure
New and Changed for Firmware Release 11.2(3)SR1
Revisions
Added a new task about getting your phone onboard
with the activation code

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.
Connect to the Network
You need to connect the phone to the network.
• Wired network connection—All wired network connections use one of the following:
Note
Your Phone
8
• PoE deployment: Connect the phone to the Cisco IP Conference Phone 8832 PoE Injector
(CP-8832-POE) and connect the injector to the network with an Ethernet cable.
• Non-PoE deployment: Connect the phone to the Cisco IP Conference Phone 8832 Non-PoE
Ethernet Injector (CP-8832-ETH or CP-8832-ETH-WW). Then, connect the injector to the network
with an Ethernet cable and plug the injector into the electric outlet.
CP-8832-ETH and CP-8832-PWR are for North America. CP-8832-ETH-WW and CP-8832-PWR-WW are
for other locations.
New and Changed Sections
Auto Provision Your Phone with Short Activation
Code, on page 10
Find Information About Your Phone, on page 23
Get More Information When Your Phone Displays a
Provisioning Failure Message, on page 29
New or Changed Sections
Onboard Your Phone with Activation Code, on page
9
Your Phone