Cisco 8831NR Administration Manual page 62

Pair Wireless Microphone
Table 18: Wireless Microphone Options
Option
Wireless Microphone 1
Wireless Microphone 2
Wireless Microphone Range
Pair Wireless Microphone
Before you begin
The microphone must be in the off state before you can pair it to the conference station. A microphone is off
if the microphone's LED is off. To turn off the wireless microphone, hold down the microphone button until
the microphone LED turns solid red, then release.
Procedure
Step 1
Choose Apps > Admin Settings > Wireless Microphones.
Step 2 Select either Wireless Microphone 1 or Wireless Microphone 2.
If the selected channel is available, a Pair microphone 1? or Pair microphone 2? prompt displays,
and the Pair softkey displays.
If a microphone is already linked to a particular channel, pairing cannot be initiated on the selected channel
and the dialog shows that the microphone is linked.
Step 3 Press Pair.
If the channel is ready to pair, the pairing process begins and a text message displays.
Step 4 Put the microphone that corresponds to the selected channel in pairing mode by pressing the microphone's
Mute button until the LED lights solid red.
If pairing succeeds, the screen reverts to the Wireless Microphones Menu, and the message Mic X Paired
Successfully! displays.
If pairing times out or fails, the status is updated and you can cancel or retry.
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
52
Description
The channel that can be used to pair
the first microphone.
The channel that can be used to pair
the second microphone.
Sets the baseband power and
effective RF range for the wireless
microphones.
The RF range can be set to
• Low
• Medium
• High
Cisco Unified IP Conference Phone Installation
To Change
See Pair Wireless Microphone, on
page 52 or Unpair Wireless
Microphone, on page 53
See Pair Wireless Microphone, on
page 52 or Unpair Wireless
Microphone, on page 53
Select Low, Medium or High, and
press Select. Or press Default to
select the default setting and press
Select.