Feature Support; Phone Setup; Connect The Cisco Webex Room Phone To Your Network - Cisco Webex Room Phone User Manual

Feature Support

The phone has four built-in microphones to provide 360-degree coverage. This coverage lets you speak in a
normal voice and be heard clearly from up to 10 feet (3 m) away. It also features technology that resists
interference from mobile phones and other wireless devices. This assures delivery of clear communications
without distractions. With the base unit alone, the phone provides coverage for a 20 x 20 feet (6.1 m x 6.1 m)
room and up to 10 people.
Two wired expansion microphones are available for use with the phone. Placing the expansion microphones
away from the base unit provides greater coverage in larger conference rooms. With the base unit and wired
expansion microphones, the phone provides coverage for a 20 x 34 feet (6.1 m x 10 m) room and up to 22
people.
Feature Support
This document describes all the features that the device supports. However, not all features may be supported
with your current configuration. For information on supported features, contact your administrator.

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.

Connect the Cisco Webex Room Phone to Your Network

After the phone connects to the network, the phone startup process begins, and the phone connects with your
network. If you disable the DHCP service, you must configure the network settings on the phone.
After the phone connects, it downloads a new firmware load if needed.
Before you begin
Choose the power source for the phone:
• Power over Ethernet (PoE)—For administrators who require a consistent AC power source but only want
• Ethernet with a Cisco Aironet Power Injector—For administrators who require a consistent, efficient AC
Procedure
Connect the phone to the network.
• If you use PoE:
• If you do not use PoE:
Cisco Webex Room Phone User Guide
2
REVIEW DRAFT - CISCO CONFIDENTIAL
a single cable. PoE is easier to manage, but it can use more electricity. You should confirm that your
device connects to a RJ-45 port that supports PoE.
power source and who have space for additional cables.
a. Plug the Ethernet cable to the LAN port.
b. Plug the other end of the Ethernet cable to the RJ-45 port on the rear side of the phone.
Your Phone