Connecting The Library; Figure 9 Rear Panel Cable Connectors - Quantum PowerStor L200 Series User Manual

Chapter 2 Installing the Library

Connecting the Library

Connecting the Library
Figure 9 Rear Panel
Cable Connectors
16
Complete the following procedure to connect the power cord and
SCSI cables to the library (see
Caution: Verify that the library controller is connected to the
same type of SCSI bus as the drive on that bus. For
example, connecting a single-ended SCSI library to a
differential SCSI adapter will cause a host system
malfunction.
Connect to a
SCSI device
(or install
terminator)
Connect
together
Connect to
host
To connect the library:
Verify that the library's power switch is in the off position. It is
1
not necessary to power down the host.
Connect one end of the short SCSI cable supplied with the to
2
the library controller's SCSI connector closest to the tape drive
(see figure 10).
Quantum|ATL PowerStor L200 Series Library User's Guide
figure 9).
Serial port
(FSE use only)
2
Tape drive assembly
SCSI connectors
(library controller)
Power switch
Power connector
Power supply