Figure 10 Scsi Cabling Stand-Alone Connection Scenario - Quantum PowerStor L200 Series User Manual

Figure 10 SCSI
Cabling stand-alone
Connection Scenario
Connect the other end of the short SCSI cable to the tape drive
3
SCSI connector closest to library controller.
If the is a stand-alone external SCSI device, install the SCSI
4
terminator in the connector at the far left (looking at the back of
the library). Verify that the SCSI bus is terminated properly.
Note: Depending on the system configuration, the SCSI bus
initiates at the host, connects to the library controller,
then to the tape drive, and then to any other SCSI
devices on the bus. It must be terminated at the last
SCSI device on the bus (see
SCSI cable to next SCSI
device (or install the
supplied teminator)
Supplied SCSI cables
Host
Connect one end of the long SCSI cable supplied with the
5
library to the SCSI connector closest to the power switch on the
back of the library. Connect the other end of this cable to the
host's SCSI adapter connector.
Secure the cables, using the wire cable clamps or screws
6
provided.
Connect the power cord to the power connector on the back of
7
the library (see
Connect the other end of the power cord to the site power.
8
Quantum|ATL PowerStor L200 Series Library User's Guide
figure 9).
Chapter 2 Installing the Library
Connecting the Library
figure 10).
Drive (SCSI ID 1)
Library Controller
(SCSI ID 0)
Library (Top)
17