To arm the external analyzer on signal from BNC
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify interactive measurement specification?" question.
3 Answer "drive" to the "Should BNC drive or receive Trig2?" question.
4 Answer "receive" to the "Should External Analyzer drive or receive Trig2?"
question.
To arm the external analyzer on emulation
analyzer trigger
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify interactive measurement specification?" question.
3 Answer "drive" to the "Should Analyzer drive or receive Trig2?" question.
4 Answer "receive" to the "Should External Analyzer drive or receive Trig2?"
question.
Chapter 10: Making Coordinated Measurements
Using Trigger Signals
353