To Drive The Emulation Analyzer Trigger Signal To The Cmb - HP 64746 User Manual

This section shows you how to:
•
Drive the emulation analyzer trigger signal to the CMB.
•
Drive the emulation analyzer trigger signal to the BNC connector.
•
Drive the external analyzer trigger signal to the CMB.
•
Drive the external analyzer trigger signal to the BNC connector.
•
Break emulator execution on signal from CMB.
•
Break emulator execution on signal from BNC.
•
Break emulator execution on external analyzer trigger.
•
Arm the emulation analyzer on signal from CMB.
•
Arm the emulation analyzer on signal from BNC.
•
Arm the emulation analyzer on external analyzer trigger.
•
Arm the external analyzer on signal from CMB.
•
Arm the external analyzer on signal from BNC.
•
Arm the external analyzer on emulation analyzer trigger.
To drive the emulation analyzer trigger signal to
the CMB
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify interactive measurement specification?" question.
3 Answer "receive" to the "Should CMBT drive or receive Trig1?" question.
You could also drive the emulation analyzer trigger to the CMB over the trig2
internal line by specifying that the CMBT should receive trig2 and that the
emulation analyzer should drive trig2.
Chapter 10: Making Coordinated Measurements
Using Trigger Signals
347