HP 64746 User Manual page 320

Using the External State Analyzer
The HP 64703A analyzer provides an external analyzer with 16 external trace
channels. These trace channels allow you to capture activity on signals external to
the emulator, typically other target system signals. The external analyzer may be
configured as an extension to the emulation analyzer, as an independent state
analyzer, or as an independent timing analyzer.
When the external analyzer is configured as an independent state analyzer, the
emulator/analyzer interface does not control the external analyzer. However, you
can use pod commands to control the independent state analyzer via the terminal
interface. Refer to the 68302 Emulator Terminal Interface User's Guide for
information on using the external analyzer when it is configured as an independent
state analyzer.
When the external analyzer is configured as an independent timing analyzer, you
must use a special Timing Analyzer Interface program. Refer to the Timing
Analyzer Interface User's Guide for information on using the external analyzer
when it is configured as an independent timing analyzer.
The tasks you perform with the external analyzer are grouped into the following
sections:
•
•
320
Setting up the external analyzer.
Configuring the external analyzer.