Table of Contents
Advertisement
Chapter 1: Getting Started
Step 12: Patch assembly language code
Notice in the emulator/analyzer interface that the instruction at address "main" has
changed.
4 Click on the Patch () action key again.
A window running the vi editor again appears, allowing you to modify the patch
code that was just created. Modify the line you added previously to:
LINK A6,#0
Exit out of the editor, saving your changes.
The file you just edited is assembled, and the patch main menu appears. Type "a"
and press <RETURN> to apply the patch.
Notice in the emulator/analyzer interface that the instruction at address "main" has
been changed back to what it was originally.
When patching a single address, make sure the new instruction takes up the same
number of bytes as the old instruction; otherwise, you may inadvertently modify
code that follows.
45
Advertisement
Table of Contents
