Chapter 9: Using the External State Analyzer
Configuring the External Analyzer
to extend past bit 15. Thus, the sum of the start bit number plus the width must not
exceed 16.
The "polarity?" question allows you to specify positive or negative logic for the
external bits. In other words, positive means high=1, low=0. Negative means
low=1, high=0.
Once external labels are defined, they may be used in trace commands to qualify
events (if the emulation controls the external analyzer). Also, you can modify the
trace display to include data for the various trace labels.
Note that the Timing Analyzer Interface does not use the external labels defined in
the emulator/analyzer interface. You maintain labels for the timing analyzer within
the Timing Analyzer Interface itself.
333