Table of Contents
Advertisement
Chapter 12: Emulator/Analyzer Interface Commands
performance_measurement_initialize
performance_measurement_initialize
This command sets up performance measurements.
The emulation system will verify whether a symbolic database has been loaded. If
a symbolic database has been loaded, the performance measurement is set up with
the addresses of all global procedures and static symbols. If a valid database has not
been loaded, the system will default to a predetermined set of addresses, which
covers the entire emulation processor address range.
The measurement will default to "activity" mode.
Default values will vary, depending on the type of operation selected, and whether
symbols have been loaded.
The parameters are as follows:
activity
This option causes the performance measurement process to operate as though an
option is not specified.
434
Advertisement
Table of Contents
