Table of Contents
Advertisement
620
Unexpected software breakpoint
Cause: If you have enabled software breakpoints, this message is displayed if a
software breakpoint instruction is encountered in your program that was not
inserted by a modify software_breakpoints set command and is therefore not in
the breakpoint table.
Action: Remove the breakpoint instructions in your code before assembly and link,
and use the modify software_breakpoints set command to reinsert them after the
program is loaded into memory.
621
Unexpected step break
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
622
%s
Cause: Monitor specific message.
623
CMB execute break
Cause: This message occurs when coordinated measurements are enabled and an
EXECUTE pulse causes the emulator to run; the emulator must break before
running.
Action: This is a status message; no action is required.
624
Configuration aborted
Cause: Occurs when a <CTRL>c is entered while emulator configuration items are
being set.
626
Configuration failed; setting unknown: %s=%s
Cause: Target condition or system failure.
Action: Check target system, and run performance verification (Terminal Interface
pv command).
Chapter 13: Error Messages
Terminal Interface Messages
515
Advertisement
Table of Contents
