HP 64746 User Manual page 571

Installing HP 9000 Software
This section shows you how to install the Graphical User Interface on HP 9000
workstations. These instruction also tell you how not to install the Graphical User
Interface if you want to use just the conventional Softkey Interface.
This section shows you how to:
1 Install the software from the media.
2 Verify the software installation.
3 Start the X server and the Motif Window Manager (mwm), or start HP VUE.
4 Set the necessary environment variables.
Step 1. Install the software from the media
The tape that contains the Graphical User Interface software may contain several
products. Usually, you will want to install all of the products on the tape.
However, to save disk space, or for other reasons, you can choose to install selected
filesets.
If you plan on using the Softkey Interface instead of the Graphical User Interface,
you can save about 3.5 megabytes of disk space by not installing the XUI suffixed
filesets in the "64700 Operating Environment" and "<processor-type> Emulation
Tools" partitions. (Also, if you choose not to install the Graphical User Interface,
you will not have to use a special command line option to start the Softkey
Interface.)
Refer to the information on updating HP-UX in your HP-UX documentation for
instructions on viewing partitions and filesets and marking filesets that should not
be loaded.
The following sub-steps assume that you want to install all products on the tape.
Chapter 16: Installation
Step 1. Install the software from the media
571