Table of Contents
Advertisement
Chapter 12: Emulator/Analyzer Interface Commands
pod_command
pod_command
Allows you to control the emulator through the direct HP 64700 Terminal Interface.
The HP 64700 Card Cage contains a low-level Terminal Interface, which allows
you to control the emulator's functions directly. You can access this interface
using pod_command. The options to pod_command allow you to supply only
one command at a time. Or, you can select a keyboard mode which gives you
interactive access to the Terminal Interface.
There are certain commands that you should avoid while using the Terminal
Interface through pod_command.
stty, po, xp
echo, mac
wait
init, pv
t
To see the results of a particular pod_command (the information returned by the
emulator pod), you use display pod_command.
Refer to the 68302 Emulator Terminal Interface User's Guide for information on
using the Terminal Interface to control the emulator.
438
Do not use. These commands will change the operation of the
communications channel, and are likely to hang the Softkey
Interface and the channel.
Using these may confuse the communications protocols in use
on the channel.
Do not use. The pod will enter a wait state, blocking access by
the emulator/analyzer interface.
These will reset the emulator pod and force an end
release_system command.
Do not use. The trace status polling and unload will become
confused.
Advertisement
Table of Contents
