To Restore Trace Commands - HP 64746 User Manual

To restore trace commands

• Choose File→Load→Trace Spec.
• Using the command line, enter the load trace_spec command.
Trace commands that are restored will always work, even if symbols have been
changed; however, once you modify the trace command, it may no longer work.
Loading a trace specification does not start the trace; to do this, you must enter the
trace command either by selecting it from the Trace Specification Selection dialog
box or by using the Trace→Again pulldown menu item.
Examples
To bring back the trace command saved in "tspecfile.TS" and perform a trace
measurement using it:
load trace_spec tspecfile <RETURN>
trace again <RETURN>
Chapter 7: Using the Emulation Analyzer
Saving and Restoring Traces
285