HP 64746 User Manual page 10

Contents
Modifying the General Configuration Items
To select the emulator clock source
To enable/disable entry into the monitor after configuration
To restrict the emulator to real-time runs
To turn OFF the restriction to real-time runs
To select the inverse assembly syntax
Selecting the Emulation Monitor Program
To use the background monitor program
To use a foreground monitor program
Mapping Memory
To map memory ranges
To characterize unmapped ranges
To delete memory map ranges
To map memory ranges that use function codes
Configuring the Emulator Pod
To enable/disable bus arbitration
To specify the analyzer's response to bus arbitration
To enable/disable emulation memory synchronization
To enable/disable /BERR connection to target system
To enable/disable response to target system interrupts
To select the normal or dedicated interrupt mode
To set the reset value for the Supervisor Stack Pointer
To set the processor data bus width
To specify the target memory access size
To select /IACK7 or PB0
To drive background cycles to the target system
To stop driving background cycles to the target system
To specify /DTACK sources for chip selects
Setting the Debug/Trace Options
To enable/disable breaks on writes to ROM
To specify which TRAP instruction is used for software breakpoints
To include/exclude background states in the trace
10
108
110
111
111
115
116
120
121
123
124
127
128
134
134
135
137
138
138
108
109
112
125
129
130
131
132
132
133
135
136
139
140