Table of Contents
Advertisement
Chapter 4: Configuring the Emulator
Selecting the Emulation Monitor Program
To assemble and link the monitor program, enter the following commands (which
assume that $HP64000/bin is defined in the PATH environment variable):
$ as68k -hL Mfmon68302.s > Mfmon68302.lis <RETURN>
$ ld68k -hc Mfmon68302.k -L > Mfmon68302.map <RETURN>
Where the "Mfmon68302.k" linker command file is:
name Mfmon68302
load Mfmon68302.o
end
To configure the emulator to use a foreground monitor program, access the
configuration questions, and answer the questions as shown below.
Re-map memory for the emulator demo program by entering the following mapper
commands:
0 thru 0ffffh emulation ram <RETURN>
80000h thru 87fffh emulation ram <RETURN>
0fff000h thru 0ffffffh target ram <RETURN>
end <RETURN>
To load the demo program absolute file, enter the following command using the
command line:
load ecs <RETURN>
118
Inverse assembly syntax to use? 64870
Modify memory configuration? yes
Monitor type? foreground
Reset map (change of monitor type requires map reset)? yes
Monitor address? 10000h
Monitor file name? Mfmon68302.X
Configuration file name? fmoncfg
Advertisement
Table of Contents
