Font, Selecting Default (Version Ii) - Printronix L7032 Programmer's Reference Manual

Chapter 2
Command Codes
Comment When loading fonts to RAMDISK, the printer files will not be

Font, Selecting Default (Version II)

Purpose
Mode
Format
78
(cc)G The universal terminator. Enter the SFCC for your
VGL configuration immediately followed by G to
terminate the ILOAD, command.
data The binary TrueType font or Intellifont data to be
stored in memory.
(cc)G The universal terminator. Enter the SFCC for your
VGL configuration immediately followed by G to
terminate the binary font data parameter.
(cc)- Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
saved to RAMDISK when the printer is powered off. When
loading fonts to flash memory, the printer files will be saved when
the printer is powered off. Both RAMDISK and flash memory
support file operations such as saving, reading, and deleting files.
Selects a default font.
Standard Graphics or Graphics with an Extended Graphics
Command selected. When this command is executed as an
Extended Graphics command, descender mode automatically
turns on.
(cc) IFONT,S, n (cc)G
or
(cc) IFONT,N, name (cc)G
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
IFONT, Specifies the IFONT command. Enter IFONT,.
S, n Represents the selected font value. Enter S,.
Replace n with a value ranging from 1 through 13,
or 100 or 101, according to the IFONT values
shown in Table 9 or as shown in the Font Values
section below.
N, name Represents the selected TrueType font or Intellifont
(AGFA) by name. Enter N, and the name of the font
with its extension. The maximum length of the
name is 8 characters and the maximum length of
the extension is 3 characters. For example,
93952.sf specifies Courier Bold (AGFA) and
arial.ttf represents Arial (TrueType). If this
parameter is used, then IFONT S, should not be
used.
(cc)G The universal terminator. Enter the SFCC for your
VGL configuration immediately followed by G to ter-
minate the IFONT,S, command.