Extended Graphics Commands - Printronix L7032 Programmer's Reference Manual

Table 2. Standard Graphics Commands (continued)
Command Description
N Special Function Control Code Change
T Tab, Horizontal (Set Graphics Margin)
+ Tab, Vertical
@U Underlined Print

Extended Graphics Commands

Specific graphics functions (lines, boxes, alphanumerics, forms, bar codes,
reverse printing, etc.) are available through commands sent as part of an
extended graphics command sequence. Table 3 summarizes the extended
graphics commands, which are fully described on the referenced pages.
Extended commands must be used as part of an alphanumeric command
sequence (after VGL is in the Graphics Mode). In some cases, the actual
command may have a different meaning and perform a different function
when used within an extended graphics command sequence compared to its
use as a standard graphics command.
NOTE: An alphanumeric command from Table 1 must be used before issuing
Command Description
IBARC, Bar Code (Version II)
B Bar Code, Horizontal
C Bar Code, Vertical
LB Boxes
H Character Height
W Character Width
in Character Set Selection
KF Dark Print
D Descending Characters
IREPH, Duplication, Horizontal (Version II)
IREPV, Duplication, Vertical (Version II)
f Fill (for Standard and Expanded User-Defined Symbols)
IFONT,S, Font, Selecting Default (Version II)
Font Fonts, Rotatable
an Extended Graphics Command.
Table 3. Extended Graphics Commands
Extended Graphics Commands
Page #
Page #
144
151
155
156
164
160
160
39
42
44
343
49
51
56
63
148
78
82
29