Selecting An Iso Character Set - Printronix L7032 Programmer's Reference Manual

Chapter 5
Accessing Characters And Character Sets

Selecting An ISO Character Set

Purpose
Mode
Format
n ISO Character Set
0 USA
1 UK
2 Swedish/Finnish
3 Norwegian/Danish
4 Japanese
5 German
6 French
7 Italian
8 Spanish
Comments
346
Accesses one of nine ISO character sets.
Standard Graphics or Graphics with an Extended Graphics
Command selected
(cc) IISO, n (cc)G
(cc) Represents the Special Function Control Code.
IISO, The ISO Character Set Selection command; enter
IISO, (the comma is required).
n The character substitution set number; enter a
value ranging from 0 through 8 according to the
desired character set shown in Table 73. If n is not
a value from 0 through 8, an error message is
displayed and the command is ignored.
Table 73. IISO, Character Sets
23 24 40 5B 5C
# $ @ [ \
£ $ @ [ \
# $ É Ä Ö
# $ @ Æ Ø
# $ @ [ ¥
# $ § Ä Ö
£ $ á 5 ç
£ $ § 5 ç
¡
£ $ § Ñ
(cc)G The universal terminator. Enter the SFCC for your
VGL configuration immediately followed by G to
terminate the IISO, command.
When the IISO, command is used in a Standard Graphics
command, the printer font set is changed to the new ISO
character set. When the IISO, command is used with an
Extended Graphics command selected, only the Extended
character set is changed to the new ISO character set.
Hex Value:
5D 5E 60 7B
`
] ^ {
`
^
] {
Å Ü é ä
Å
Ü ` æ
`
] ^ {
`
Ü ^ ä
`
^
§ é
^
é ù à
¿ 5
`
^
7C 7D 7E
| } ~
-
| }
ö å ü
ø å ü
-
|
}
ö ü ß
ù è
¨
ì
ò è
ñ ç ~