Printronix L7032 Programmer's Reference Manual page 58

Chapter 2
Command Codes
Example
^PY^-^F^-
^R0003^-^M03,03,000A Line^LS0100,0010^-
^M^D^S4compressed characters^-
^M^D^S1Repeated 3 times^*^*^Z^-
^O^-^PN^-
58
One Vertical Duplication command can be
contained within a Vertical Duplication command.
The total number of characters within the command
sequence (including all repetitions) must be 256
characters less than the maximum size of the input
buffer.
(cc)Z(cc)- Mandatory Vertical Duplication command
sequence terminator. Enter the SFCC for your VGL
configuration immediately followed by Z, another
SFCC, and - to end terminate the Vertical
Duplication command sequence. If a Vertical
Duplication command is nested within a Vertical
Duplication command, this single terminator
sequence terminates both Vertical Duplication
commands.
If Auto Increment/Decrement command parameters
are used with this command (page 59), this
terminator causes all the numeric fields to increase/
decrease (as specified by the Auto Increment/
Decrement command) at the end of the repeat
pass. If the (cc)ZO(cc)- (alpha O) terminator is
used, all numeric fields are updated sequentially
within the repeat pass. See "Auto Increment/
Decrement Vertical Duplication" on page 59 for
more information.
The following example illustrates the Vertical Duplication
command. Alphanumeric commands, line elements, and
standard graphics commands are repeated 3 times down the
page. (The ^*^* causes the two line feeds on which the data is
repeated. See the Free Format commands discussed on pages
99 and 102.)
vertdu