Character Set Selection Command - Printronix L7032 Programmer's Reference Manual

Character Set Selection Command

Purpose Accesses one of the multinational (Table 69) or international
(Table 74) character sets. Use this command to access a
different character set from the configured power-up default
character set.
Mode Graphics
As a stand-alone command: (cc) i n (cc)-
Format
Within a graphics command: (cc) i n M ht wd jus data (cc)-
(cc)
i
n
M ht wd jus data
(cc)-
Comment The stand-alone command must appear in the first column of a
line.
Example The following example shows the Character Set Selection
command as a stand-alone command which activates the
German character set: ^i1^-
Issue the Character Set Selection command as many times as
required for a form. The character set selected remains active
until a new set is selected.
The (cc) i n (cc)- command is inactive in the Normal Mode.
However, plotted text data prints (in a compressed print mode) in
the character set selected.
Character Set Selection Command
Represents the Special Function Control Code.
The Character Set Selection command; enter i.
The character substitution set number; enter a
value from the multinational (Table 69) or
international (Table 74) character set tables.
Character sets 0 through 23 represent resident
character sets. Values from 24 through 31
correspond to the customized user-defined
character sets 1 through 8, respectively. Character
sets 32 and above represent the International
Character sets listed in Table 74.
See Chapter 2 for a description of these
alphanumeric command parameters.
The command terminator. Enter the SFCC for your
VGL configuration immediately followed by -
(Graphics Mode CR) or other valid terminator. The
terminator must be entered to stop this function.
343