Table of Contents
Advertisement
Command
Sub-Command
CONFIG
LOAD
SAVE
POWERUP
PRINT
CONFIG
DELETE
UPLOAD
DOWNLOAD
RESET
LP MODE
n/a
Table 76. PTX_SETUP Commands
Parameter
Cfg
Cfg
Cfg
Cfg
Cfg
Port;Cfg
Cfg
Protocol
Description
Cfg can be 0-8. The PTX_SETUP
will load configuration Cfg . If
configuration Cfg was not previously
saved, the operator panel will
display an error message and the
current configuration will be kept.
Cfg must be 1-8. This command will
save the current configuration as
configuration Cfg . If Cfg is not in the
range of 1-8, the command is
ignored.
Sets the power-up configuration to
Cfg and loads Configuration Cfg .
Cfg can be any value from 0-8,
where 0 is the factory default.
Print Configuration Cfg . Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL
configuration(s).
Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
This command uploads the
configuration stored in location Cfg
to the port specified by Port . Port
must either be 1284 or SERIAL. Cfg
may be 1-8 or ALL.
This command saves the
configuration data that follows as
configuration Cfg. Cfg must be 1-8
or END.
Reboots the printer.
Protocol must be 0-4. This
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2 - Serial Matrix
3 - Proprinter III XL
4 - Epson FX-1050
Commands
383
Advertisement
Chapters
Table of Contents
