Printronix L7032 Programmer's Reference Manual page 356

Chapter 6
Error Codes
32
33
34
35
36
37
38
39
40
41
43
44
45
47
48
49
356
Dot Slew Command Error
A Dot Slew command (D) contains a non-numeric dots
parameter.
Line Slew Command Error
A Line Slew command (K or W) contains a non-numeric lines
parameter.
Forms Length PI Error
A Forms Length command (L) must use the PI line, but VGL is
configured with PI disabled. Use the H Forms Length command.
Forms Length No PI Error
A Form Length command (H) cannot use the PI line, but VGL is
configured with PI enabled. Use the L Forms Length command.
Dynamic Form Copy Command Error
A Dynamic Form Copy command (C) contains a non-numeric
parameter.
Dynamic Form Field Length Command Error
A Dynamic Form Field Length command ([ length or { length )
contains a non-numeric length parameter.
Dynamic Form Nested Copy Error
A Dynamic Form Copy command (C) was encountered while
already within a copy loop. Copy commands cannot be nested.
Dynamic Data Repeat Count Error
A repeated dynamic form data element does not have a valid
repeat count. The repeat count must be four numeric characters.
Incomplete BarCode Error
An unexpected end of a bar code command was detected. No
bar code type was found, or not enough variable ratio characters
were given.
Undefined BarCode Type Error
An undefined bar code type was given.
BarCode Data Length Error
The length of the bar code data is too long or too short for the bar
code type selected.
Illegal BarCode Data Error
The bar code data contains a character which is not allowed by
this bar code type.
BarCode Off Page Error
The bar code does not fit on the page at the starting column.
LPI Parameter Error
The new lpi parameter in the Line Spacing command (@L)
contains a non-numeric or 0 value.
Element Off Page Error
The form element cannot fit on the page at the starting position.
Not defined.