Table of Contents
Advertisement
Chapter
6
Error Codes
09
10
11
12
13
14
15
16
17
18
19
20
21
354
Form Memory Error
The form is too big and ran out of form memory during alpha or
vector buffer storage.
Character Height Command Error
A Character Height command (H) has a non-numeric character
for the height parameter.
Hex Data Error
An invalid character was found while expecting a hexadecimal
value. Only numeric characters or A, B, C, D, E, or F are allowed.
Vertical Justification Change Error
A Vertical Justification (J) command has a non-numeric character
for the justification parameter.
Form Command Error
A forms construction command (LF) has a non-numeric
parameter.
Undefined Line Command Error
The Line command (L) was not followed by B, D, F, or S.
Logo Command Error
A user-defined logo using the Z command contains an invalid
parameter value; valid values are 1 through 9 or A through F.
Plot Command Error
A Plot command (Q or C) contains invalid hexadecimal data
characters. Only numeric characters or A, B, C, D, E, or F are
allowed.
Not defined.
Vertical Duplication (Repeated Form) Terminator Missing
Error
A Vertical Duplication commands (R) does not have a line
terminator.
Horizontal Duplication Command Error
A Horizontal Duplication command (S) contains a non-numeric
character or gap space parameter or is not followed by a line
terminator.
Horizontal Tab Command Error
A Horizontal Tab command (T) contains a non-numeric distance
parameter.
Special Function Control Code Change Command Error
A Special Function Control Code (SFCC) change command (N)
contains an illegal value for x or is not followed by a line
terminator. x can be any character from hex 11 through hex FF
(decimal 17 through 255).
Advertisement
Chapters
Table of Contents
