Object Detection - Speco N64NR48TB User Manual

NVR User Manual
Alarm Management

9.4.5 Object Detection

Object Detection Configuration:
① Click StartSettingsCameraSmart SettingsObject Detection to go to the following interface.
② Select the camera, enable the object detection and set the detect type. There are two detect types: Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drew by the users.
③ Select the alarm area. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check "Draw Area" and then click around the area where
you want to set as the alarm area in the image (the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the drawing. Click
the "Clear" to delete the alarm area.
⑤ Click "Apply" to save the settings.
⑥ Click "Processing Mode" to go to the alarm handling configuration interface of object detection.
Object Detection Alarm Handling Configuration:
① Click StartSettingsAlarmSmart EventObject Detection to go to the following interface.
② Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling setting of object
detection alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click "Apply" to save the settings. You can click "Object Config" to go to the object detection configuration interface.
63