Alarm Management
② Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling settings of
motion alarm the same as the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click "Apply" to save the settings. You can click "Motion Settings" to go to the motion configuration interface.
9.3 Smart Event
9.3.1 Object Detection
Object Detection Configuration:
① Click StartSettingsCameraIntelligent AnalyticsObject Detection to go to the following interface.
② Select the camera, enable the object detection and set the detect type. There are two detect types: Abandoned object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drawn by the users.
③ Select the alarm area. A maximum of 4 alarm areas can be set.
④ Draw the alarm area of the object detection. Refer to the interface as shown above. Check "Draw Area" and then click around the area where
you want to set as the alarm area in the image (the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the drawing. Click
the "Clear" to delete the alarm area.
⑤ Click "Apply" to save the settings.
⑥ Click "Processing Mode" to go to the alarm handling configuration interface of object detection.
Object Detection Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmObject Detection to go to the following interface.
55
DVR User Manual