Speco N64NR48TB User Manual page 25

Camera Management
Add Manually

Enter the IP address or domain name (click
the IPC in the window and then click "OK" button), port, username and password of the camera and then select the protocol. Click "Test" to test
the effectiveness of the input information and then click "Add" button (you can input one camera's information or above such as IP address,
username and password before clicking "Add" button). Click
password of each camera.
Note: Some models may not support this function.
Click StartSettingsSystemBasicGeneral Settings to check "Enable Add IPC by Zero Operation". If the NVR has unoccupied channels, it can
add IPC without any operation by restarting.
Add Recorder

Quickly Add：Select the searched NVR/DVR and the click "Add" to add NVR in the same local network.

in the IP address column to pop up the domain name input window, enter the domain name of
to delete the camera. Click "Default Password" to set the default username and
18
NVR User Manual