Object Detection - Speco N64NR24TB User Manual

Alarm Management
for details).
③ Click "Apply" to save the settings. You can click "People Counting Config" to go to the people counting detection
configuration interface.

9.4.5 Object Detection

Object Detection Configuration:
1 Click StartSettingsCameraSmart SettingsObject Detection to go to the following interface.
2 Select the camera, enable the object detection and set the detect type. There are two detect types: Abandoned
object and missing object.
Abandoned object: Alarms will be triggered if there are articles left in the pre-defined detection area.
Missing object: Alarms will be triggered if there are articles missing in the detection area drew by the users.
3 Select the alarm area. A maximum of 4 alarm areas can be set.
4 Draw the alarm area of the object detection. Refer to the interface as shown above. Check "Draw Area" and then
click around the area where you want to set as the alarm area in the image (the alarm area should be a closed area).
Uncheck the "Draw Area" if you finish the drawing. Click the "Clear" to delete the alarm area.
5 Click "Apply" to save the settings.
6 Click "Processing Mode" to go to the alarm handling configuration interface of object detection.
Object Detection Alarm Handling Configuration:
1 Click StartSettingsAlarmSmart EventObject Detection to go to the following interface.
2 Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm
65
NVR User Manual