Recorder Osd Settings; Factory Default; Device Software Upgrade - Speco N64NR48TB User Manual

Device Management

11.2.3 Recorder OSD Settings

Click StartSettingsSystemBasicRecorder OSD settings to go to the following interface. OSD name and icon can be enabled here.

11.3 Factory Default

Click StartSettingsSystemMaintenanceFactory Default and then click "Reset to factory default" button in the interface to reset to the
factory default settings (check "Reset retain Network Configuration" to retain the network settings).
Note: Resetting to the factory default settings will not change time zone.

11.4 Device Software Upgrade

Upgrade

You can click StartSettingsSystemInformationBasic to view MCU, kernel version and firmware version and so on. Before upgrade, please
get the upgrade file from your dealer.
The upgrade steps are as follows:
① Copy the upgrade software into the USB storage device.
② Insert the USB storage device into the USB interface of the NVR.
③ Click StartSettingsSystemMaintenanceUpgrade to go to "Upgrade" interface. Select the USB device in "Device Name" option and go
85
NVR User Manual