Push Message; Alarm Server; Manual Alarm - Speco N64NR48TB User Manual

Alarm Management

9.6.5 Push Message

Click StartSettingsAlarmEvent NotificationPush Message to go to the interface as shown below. Check "Enable" and then click "Apply"
button to save the settings. If Push Server is online, it will push messages to the mobile clients.

9.6.6 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select protocol. If "Send Heartbeat" is enabled, set the interval
times. After that, test the effectiveness of the alarm server. Having tested successfully, please click "Apply". When an alarm occurs, the device will
transfer the alarm event to the alarm server. If an alarm server is not needed, there is no need to configure this section.

9.7 Manual Alarm

Click on the tool bar at the bottom of the live view interface to pop up a window. Click "Trigger" to start alarm. Click "Clear" to stop alarm.
69
NVR User Manual