Alarm Management
9.4.2 Crowd Density Detection
Only some versions may support this function. If your NVR doesn't support this function, please skip the following instructions.
Crowd Density Configuration:
Alarms will be triggered if the crowd density exceeds the set threshold value in the pre-defined area.
① Click StartSettingsCameraSmart SettingsCrowd Density to go to the following interface.
②Select the camera, enable the crowd density detection and set the duration, refresh frequency and alarm threshold.
Refresh Frequency: It refers to the refresh time of the detection result report.
Alarm Threshold: Alarms will be triggered once the percentage of the crowd density in a specified area exceeds the pre-defined threshold value.
③ Select the alarm area. Draw the alarm area of the crowd density detection. Refer to the interface as shown below. Check "Draw Area" and then
drag the mouse to draw a rectangle area. Uncheck the "Draw Area" if you finish the drawing. Click the "Clear" to delete the alarm area.
④ Click "Apply" to save the settings.
⑤Click "Processing Mode" to go to the alarm handling configuration interface of crowd density detection.
Crowd Density Detection Alarm Handling Configuration:
① Click StartSettingsAlarm Crowd Density to go to the following interface.
② Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling setting of
crowd density detection alarm is similar as the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click "Apply" to save the settings. You can click "Crowd Density Config" to go to the crowd density detection configuration interface.
60
NVR User Manual