Combination Alarm; Smart Event; Face Detection - Speco N64NR48TB User Manual

Alarm Management
② Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling settings of
motion alarm the same as the sensor alarm (see 9.1 Sensor Alarm for details).
③ Click "Apply" to save the settings. You can click "Motion Settings" to go to the motion configuration interface.

9.3 Combination Alarm

① Click StartSettingsAlarm Combination Alarm to go to the following interface.
② Customize combination alarm. Set alarm name and click "Configure" under the Combined Alarm Configuration item. Then select alarm type
and alarm source. Finally, click "OK" to save the settings.
③ Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling setting of
combination alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
④ Click "Apply" to save the settings.

9.4 Smart Event

9.4.1 Face Detection

Face Detection: Alarms will be triggered if target people intrude into the pre-defined alarm areas.
① Click StartSettingsCamera Smart Settings Face Detection to go to the following interface.
58
NVR User Manual