Preparing The Pump Set - KSB Amacan P 500-270 Installation & Operating Manual

60 of 112
7 Servicing/Maintenance
WARNING
Unqualified personnel performing work on the pump (set)
Risk of injury!
▷ Always have repair work and maintenance work performed by specially trained,
qualified personnel.
WARNING
Hot surface
Risk of injury!
▷ Allow the pump set to cool down to ambient temperature.
WARNING
Improper lifting/moving of heavy assemblies or components
Personal injury and damage to property!
▷ Use suitable transport devices, lifting equipment and lifting tackle to move
heavy assemblies or components.
WARNING
Excess pressure inside the pump set
Risk of injury when opening the pump set!
▷ Take care when opening the inner chambers. Equalise the pressure.
WARNING
Components with sharp edges
Risk of cutting or shearing injuries!
▷ Always use appropriate caution for installation and dismantling work.
▷ Wear work gloves.
WARNING
Pump set tilting or rolling off
Risk of personal injury!
▷ Make sure the pump set is secured against tilting during the entire dismantling
process.
▷ For dismantling the pump set in a horizontal position, secure it against rolling
off.
Observe the general safety instructions and information.
For dismantling and reassembly observe the general assembly drawing.
In the event of damage you can always contact our service departments.

7.5.2 Preparing the pump set

1. De-energise the pump set and secure it against unintentional start-up.
2. Remove the pump set from the discharge tube. (ð Section 7.3.1, Page 52)
3. Clean the pump set. (ð Section 7.3.2, Page 54)
4. Drain the lubricant. (ð Section 7.4.1.4, Page 57)
5. Drain the leakage chamber and leave it open for the duration of the
disassembly. (ð Section 7.3.5, Page 55)
Amacan P