KSB Amacan P 500-270 Installation & Operating Manual page 34

Submersible pump in discharge tube
Hide thumbs Also See for Amacan P 500-270:
Table of Contents

Advertisement

34 of 112
5 Installation at Site
11. Insert the support rope (f) and the control cable (c) into the spacer (a) and make
sure that they are in their respective ducts.
12. Tighten the cables with the manila rope running over the crane hook.
13. Insert the power cables (b) into the hollows of the spacer (a) and, starting from
the bottom, firmly clamp the power cables with cable clamps (d) covered by a
plastic sheath (e).
14. Progressively lower the pump set into the discharge tube while securing the
cable bundle with evenly spaced sheathed cable clamps.
15. In the area of the lifting lug between the rope sections, lay all cables in loops
and fasten them to the rope section above.
16. Fit a heat shrink tube on any protruding sharp-edged rope ends (e.g. at the
ferrule) to prevent any damage to the power and control cables.
17. Trim the spacer (a) to suit the position of support 59-7 at the support rope (f)
and the type of installation. Insert the support rope and control cable (c).
18. Insert the power cables (b) into the hollows of the spacer (a) and firmly clamp
the power cables with cable clamps (d).
59-7
X
Fig. 23: Support rope with support, dimensions in mm
*) depending on the cable cross-section,
**) for 1 rope or 3 ropes = 30 mm
19. Clamp support 59-7 with guide plate 55-1 to the support rope (f).
20. Undo the screwed connection at the guide plate. Place clamp 81-39 of the guide
plate around the support rope.
21. Fasten plate 185 of the guide plate including the rod made of glass fibre
reinforced plastics to the clamp with hexagon head bolts 901, discs 550 and cap
nuts 920. Tighten the connection and secure it with Loctite 243.
(ð Section 9.2, Page 82)
NOTE
The support must be clamped firmly to the support rope. If necessary, pad out
clamp 81-39.
22. Trim the spacer to fill the space between the two ferrules and accommodate the
support.
23. Guide the power and control cables along the support to the next cable clamp.
Pull them taught and secure them with the clamp.
Amacan P
X
733.05
719.05
L
901
243
920
550
81-51
(185, 81-39)
59-24
733.05
719.05

Advertisement

Table of Contents
loading

This manual is also suitable for:

Amacan p 600-350

Table of Contents