Table of Contents
Advertisement
Battery replacement method
1.
Disconnect the battery cover from the remote control at the battery cover buckle and open the battery
cover.
2.
Insert two AAA 1.5V alkaline batteries. Note that the positive (+) and negative (-) terminals of the
batteries must match the positive (+) and negative (-) terminals in the battery case.
3.
Close the battery cover from top to bottom until it is fully aligned with the remote control.
Precautions
1.
If the remote control is not working properly, is unstable, or can't control the device, please replace the
batteries.
2.
If you do not use the remote control for a long time or the battery is exhausted, remove the battery. (Waste
batteries pollute the environment and must be handled properly.)
3.
In order to achieve the best remote control effect, please point the black launch window on the back of
the remote control at the indicator light of the device.
4.
Discard batteries in a designated disposal area. Do not throw them into a fire.
5.
Remove old batteries immediately to prevent them from leaking into the battery compartment.
6.
Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a cloth. If
chemicals touch your skin then wash it immediately.
7.
Do not mix old and new batteries.
8.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (NiCd, NiMH, etc.) batteries.
9.
Do not continue using the remote if it gets warm or hot.
10. If any of these issues occur, call our Support Center immediately on the support website.
Effective range
1.
Remote control distance: The distance from the front of the remote control is valid within 8m.
2.
Remote control angle: With the remote control receiving window of the device as the apex, the angle in
horizontal direction at the distance of 6m is at least ±30°, and the angle in vertical direction is at least
±15°.
3
Advertisement
Table of Contents
