Hisense HAIO136 User Manual page 32

Wall Mount Installation
Fix the 4pcs of crossbeam to the wall according to the positions and dimensions of the wall mount and the
assembled product shown in the figure below (uses 5pcs of ST8×55C screw and 5pcs of expansion tube for
each crossbeam). Pay attention that when punching holes in the wall, the position and size of holes should be
calculated and measured according to the position and dimension diagram of the assembled product and the
wall mount;
Mobile Cart Assembly (Optional)
1 Unpack the mobile cart; check if the mobile cart parts are complete (3pcs of crossbeam, 2pcs of pillar (left
and right)):
2 As shown in the figure below, lay a piece of cloth on the workbench (the minimum size is 1500mm (length) *
1000mm (width) * 410mm (height)) to prevent scratch. You can also use the packaging box as a workbench.
3 Place the 3pcs of crossbeam on the workbench in the arrow direction shown in the figure, with a spacing
about 615mm between each other (pay attention to the difference in the appearance of the upper two cross-
beams and the lower crossbeam).
Crossbeams
27