Time - Strong SRT 8222 User Manual

Manual Search
Country
Antenna Power
Scan Mode

7.6 Time

Set up your time zone for clock/time in your menu and system.
Time Offset
Time Zone
Auto Standby
Power On/Off
Power On
Power On Time
Power Off
Power Off Time
7.7 Option
Set up the options for languages.
OSD Language
Subtitle Language
Audio Language
Digital Audio
installed in the channel list and afterwards you can create a new favourite list
if you like. Press OK to start the scan.
Select a particular channel to do a search on just one (known) frequency.
Press OK to start the scan. The signal quality bar might
check if the frequency is indeed in use.
Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF in connector of the receiver. Select Off for passive antennas.
Select between FTA (Free-To-Air), which will only install Free-to-Air channels
or All, which will install all found channels, even if they are scrambled. Then
select Auto Search or Manual Search and press OK to start scanning.
The GMT time can automatically be determined from the incoming TV
broadcast if set to Auto. The time zone is determined from the Country
setting in the Channel Search menu. If set to Manual, you can change the
Time zone yourself in the Time Zone option. Default is Auto.
If the correct time cannot be obtained from the incoming TV broadcast,
change the Time Zone setting yourself.
Example: in case of Daylight Saving Time.
As a power saving feature, the unit will switch to Standby automatically, if no
command from the remote control is received for the set time. Options are 1
Hour, 2 Hour, 3 Hour, Off. Default is 3 hours.
You can set a time to automatically switch On and/or Off the unit every day.
The unit will start on the last watched channel.
Note: Set Auto Standby function to Off.
Set to Enable if you want to use the automatically switch On function.
Enter the switch On time with the numeric buttons on the remote control.
Set to Enable if you want to use the automatically switch Off function.
Enter the switch Off time with the numeric buttons on the remote control.
Use t u to select the language for the On-Screen Display.
Set your preference for the subtitle language priority, if available in broadcast.
Set your preference for the audio language priority, if available in broadcast.
Options are: Off, PCM, RAW HDMI On, RAW HDMI Off
PCM: All audio will be down mixed to a Stereo format on HDMI and S/PDIF
outputs.
RAW HDMI On: Raw audio information will be passed on to the HDMI
output, without down mixing to PCM Stereo, to be passed on to and
processed by a digital amplifier or home-theatre set to produce multi-
channel audio.
be useful to
15