Table of Contents
Advertisement
3.4 Connecting to a Digital Audio Amplifier with S/PDIF
By connecting your receiver to a digital amplifier or home theatre system, you can enjoy the best
possible sound quality and multi-channel audio (depending on broadcast) up to Dolby Digital.
Connect your Digital Audio Amplifier or home theatre system with a suitable cinch cable to the S/
PDIF connector on the back of the receiver.
3.5 Connecting to a Digital Audio Amplifier and TV using
HDMI
By connecting your receiver to the latest digital amplifiers or home theatre systems with HDMI
connections, you will enjoy the best possible sound quality and multi-channel audio (depending
on broadcast), up to Dolby Digital Plus. Connect the HDMI output of the receiver to an input of your
amplifier, and then connect the HDMI output of the amplifier to your TV set. Select the correct input
on your amplifier to watch and listen to programmes.
3.6 Connecting to Ethernet
Connect a CAT5 cable (or higher quality) to the LAN (RJ45) connector of the unit and the other end to
an existing switch, router or modem. The default setting is Auto (DHCP) for automatically obtaining
IPs and DNS. Select DHCP Off in Menu> System>Network Setting>IP setting to enter your own settings
if required. When setting up manually, you need to provide a unique IP address, Netmask, Gateway
and DNS for your receiver. Refer to the manual of your router or modem to setup properly. signalling
will give momentary status of connection, like cable unplugged, local network or internet.
3.7 Connecting a USB storage device
NOTE:
For proper functioning of Timeshift and recording functions, a fast USB device (such as a hard
disk drive) is needed. Interrupted playback or a distorted picture during playback or Timeshift are
indications for a low device speed. STRONG cannot guarantee proper functioning of recording and or
Timeshift functions with all USB devices.
3.8 Connecting a secondary TV.
The antenna signal is looped-through to use with another TV (either Analogue or Digital) to share the
same antenna.
8
We recommend the use of a hard disk drive USB 2.0 or higher for recording
and play back of TV events.
Fig. 7
Fig. 7
Fig. 7
Fig. 8
Advertisement
Table of Contents
