Advertisement
Setting serial ports on SLC/ALC
Set the serial ports on SLC/ALC that is installed as follows.
Setting item
CH1 to CH8
(RS-422)
CH9/CH10
(RS-422/RS485)
*1: The sensors that can be selected on SLC/ALC are indicated below.
However, the sensors that can be actually selected vary depending on the equipment setting.
Heading Sensor 1, Heading Sensor 2, Log 1, Log 2, GPS 1, GPS 2, GPS 3, GPS 4, Ship's Clock, Echo
Sounder(Depth), Echo Sounder2(Depth), AIS, NAVTEX, Anemometer(Wind), Water Temperature
Meter, Current Meter, Climate Meter, TRI, Autopilot, Rudder, Engine/Propeller, Engine Telegraph,
Thruster, Azimuth Thruster, Generator, Fin Stabilizer, YEOMAN Digitizer, RADAR1(TT RX), Gyro
Switch, RADAR2(TT RX), Alert(to CAM), Alert(from Subsystem), Alert(to BNWAS), DSC,
IAS(MODBUS), IAS(NMEA), NAV/Alert, Plotter, GPS Buoy
Section 17 Adjusting and Setting up Equipment (for Services)
Setting contents
1. Click on any of the tabs, SLC1(M) to
SLC4(M)/SLC1(S) to SLC4(S)/ALC1 to ALC4.
2. Enable the serial port of the channel by selecting the
check box.
3. Select a sensor
*1
to be connected to the channel on
the [Sensor] combo box. When not selecting a
sensor, select [ - ].
1. Click on any of the tabs, SLC1(M) to
SLC4(M)/SLC1(S) to SLC4(S)/ALC1 to ALC4.
2. Enable the serial port of the channel by selecting the
check box.
3. Select a sensor
*1
to be connected to the channel on
the [Sensor] combo box. When not selecting a
sensor, select [ - ].
17-14
Setting value
Enable: Selected
Disable: Clear
Enable: Selected
Disable: Clear
Advertisement
