Table of Contents
Advertisement
Figure 149. Installing the liquid cooling rear I/O board
Next steps
1.
Install the system
board.
2. Follow the procedure listed in
Control panel
This is a service technician replaceable part only.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
6.
Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secures the right control panel and cable cover to the system.
2. Remove the cable cover away the system.
3. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
4. Holding the cable, slide the right control panel out of the system.
176
Installing and removing system components
After working inside your
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
system.
instructions.
system.
Advertisement
Table of Contents
