Table of Contents
Advertisement
Figure 71. Set the anti-tilt wires to the locked position and tightening the screws
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in the
Removing the liquid cooling module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Remove the expansion card
WARNING:
The liquid cooling (LC) module and processor are too hot to touch for some time after the system
has been powered off. Allow the liquid cooling module and processor to cool down before handling them.
NOTE:
Rear I/O (RIO) board is different for the system with liquid cooling heat sink modules.
NOTE:
The procedure to remove the processor from the liquid cooling module is same as removing the processor from the
PHM.
Steps
1. Using a Phillips #2 screw driver, loosen the captive screw on the liquid cooling ring holder.
2. Tilt the liquid cooling ring holder to loosen the liquid cooling tubes.
108
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Advertisement
Table of Contents
