Table of Contents
Advertisement
3. Disconnect the VGA port cable from the liquid cooling (LC) rear I/O board.
4. Open the latch on the expansion card riser and slide the VGA port out of the expansion card riser.
Figure 112. Removing the VGA port
5. Install the filler bracket if not replacing the VGA port.
Next steps
1.
Replace the VGA
port.
Installing the VGA port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
NOTE:
VGA port is supported only in slot 8 of the expansion card riser.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the VGA port into the expansion card riser and close the latch.
144
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
