Table of Contents
Advertisement
3. Disconnect the liquid cooling leak detection cable from the LC RIO board.
4. Remove the liquid cooling tubes from the clip and LC RIO board.
5. Slightly lift the liquid cooling tubes surrounding the DIMM slots.
6. Using a Torx #T30 screwdriver, loosen the captive screws on the liquid cooling module.
NOTE:
Ensure the anti-tilt wires on the liquid cooling module are in locked position when loosening the captive screws.
7. Set the anti-tilt wires on the liquid cooling module to the unlock position and lift the liquid module from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 72. Removing the liquid cooling module
Next steps
1. If you are removing a faulty liquid cooling module,
replace the liquid cooling
modules, else
Installing and removing system components
remove the
processor.
109
Advertisement
Table of Contents
