Removing The Left Control Panel - Dell PowerEdge R760xa Installation And Service Manual

NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 151. Installing the right control panel
Next steps
1. Install the side wall bracket.
2. Install the cooling fan cage
3. Install the drive backplane
4. Install the air shroud.
5. Follow the procedure listed in

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secures the left control panel and the cable cover to the system.
2. Remove the cable cover away the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
178 Installing and removing system components
assembly.
cover.
After working inside your
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
system.
instructions.
system.