Table of Contents
Advertisement
Figure 102. Removing the sponges
Next steps
1.
Replace the
sponges.
Installing the sponges
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the rear mounting front PERC
NOTE:
Observe the cable routing before disconnecting the cables.
4. Sponges are required only for GPUs with bridge cards.
Steps
Holding the edges, align the sponge and insert between the drive cage and GPU riser module.
136
Installing and removing system components
Safety
instructions.
Before working inside your
module.
system.
Advertisement
Table of Contents
