NOTE:
Refer to
cable routing
NOTE:
To avoid damaging the backplane, remove the disconnected backplane cables from the cable routing clips.
NOTE:
Route the cables properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1. Align the slots on the drive backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tab clicks into place.
Figure 50. Installing the drive backplane
Next steps
1. Connect the drive backplane cables to the connectors on the system board and backplane.
2.
Install the
drives.
3. If required,
install the rear mounting front PERC
4.
Install the cooling fan cage
5. If removed,
install the air
6.
Install the drive backplane
7. Follow the procedure listed in
section for more information.
module.
assembly.
shroud.
cover.
After working inside your
system.
Installing and removing system components
87