Table of Contents
Advertisement
Figure 47. 8 x 2.5-inch NVMe drive backplane
1. BP_PWR_CTRL
2. BP_DST_SA1 (PERC to backplane)
3. BP_PWR_1 (backplane power and signal cable to system board)
Figure 48. 8 x 2.5-inch drive backplane
1. BP_PWR_CTRL
3. BP_DST_PA1 (PCIe/NVMe connector)
5. BP_ DST_PA2 (PCIe/NVMe connector)
7. BP_DST_PB2 (PCIe/NVMe connector)
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
NOTE:
The procedure to remove the backplane is similar for all backplane configurations.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
6.
Remove the
drives.
7. If required,
remove the rear mounting front PERC
8. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
Safety
instructions.
Before working inside your
cover.
shroud.
assembly.
module.
2. BP_DST_SA1 (PERC to backplane)
4. BP_ DST_PB1 (PCIe/NVMe connector)
6. BP_PWR_1 (backplane power and signal cable to system
board)
system.
Installing and removing system components
85
Advertisement
Table of Contents
