Removing The Gpu - Dell PowerEdge R760xa Installation And Service Manual

Figure 97. Installing the left GPU riser module
Next steps
1. If removed, install the
2. Connect the riser board power and signal cables to the system board.
3. Install the cooling fan cage
4. Install the air shroud.
5. Connect the GPU power, signal, and BP/PERC cables to the system board.
6. Follow the procedure listed in

Removing the GPU

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the
4. Remove the GPU riser
5. If installed, remove the bridge
Steps
1. To remove the GPU from GPU riser module:
a. Disconnect the GPU power cable from the GPU card.
b. Open the GPU card holder latches on both ends of the riser.
c. Pull the hockey stick by the pull tape.
d. Hold the GPU card by the edges and pull the card from the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
sponges.
assembly.
After working inside your
Safety
Before working inside your
sponges.
module.
cards.
system.
instructions.
system.
Installing and removing system components 131