Table of Contents
Advertisement
Table 35. System Information details (continued)
Option
System BIOS Version
System Management Engine Version
System Service Tag
System Manufacturer
System Manufacturer Contact Information
System CPLD Version
UEFI Compliance Version
Memory Settings
To view the Memory Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS
> Memory Settings.
Table 36. Memory Settings details
Option
System Memory Size
System Memory Type
System Memory Speed
Video Memory
System Memory Testing
Memory Operating Mode
Current State of Memory Operating Mode
Fault Resilient Mode Memory Size[%]
Node Interleaving
ADDDC Setting
Description
Specifies the BIOS version installed on the system.
Specifies the current version of the Management Engine firmware.
Specifies the system Service Tag.
Specifies the name of the system manufacturer.
Specifies the contact information of the system manufacturer.
Specifies the current version of the system Complex Programmable
Logic Device (CPLD) firmware.
Specifies the UEFI compliance level of the system firmware.
Description
Specifies the size of the system memory.
Specifies the type of memory installed in the system.
Specifies the speed of the system memory.
Specifies the size video memory.
Specifies whether the system memory tests are run during system boot.
The two options available are Enabled and Disabled. This option is set to
Disabled by default.
This field selects the memory operating mode. This feature is active
only if a valid memory configuration is detected. When Optimizer Mode
is enabled, the DRAM controllers operate independently in 64-bit mode
and provide optimized memory performance. When Dell Fault Resilient
Mode (FRM) is enabled, a percentage of the total installed memory is
configured to create a fault resilient zone starting from lowest system
memory address for use by select hypervisors for host virtualization
resilience. Specify the FRM percentage by using the Fault Resilient
Mode Memory Size[%] feature. When Dell NUMA Fault Resilient Mode
(FRM) is enabled, a percentage of the installed memory in every NUMA
node is configured to create a fault resilient zone for use by select
hypervisors for host virtualization resilience. Specify the FRM percentage
by using the Fault Resilient Mode Memory Size[%] feature.
Specifies the current state of the memory operating mode.
Select to define the percent of total memory size that must be used by
the fault resilient mode, when selected in the Memory Operating mode.
When Fault Resilient Mode is not selected, this option is grayed out and
not used by Fault Resilient Mode.
Enables or disables the Node interleaving option. Specifies if the Non-
Uniform Memory Architecture (NUMA) is supported. If this field is set
to Enabled, memory interleaving is supported if a symmetric memory
configuration is installed. If the field is set to Disabled, the system
supports NUMA (asymmetric) memory configurations. This option is set
to Disabled by default.
Enables or disables ADDDC Setting feature. When Adaptive Double DRAM
Device Correction (ADDDC) is enabled, failing DRAMs are dynamically
Pre-operating system management applications
37
Advertisement
Table of Contents
